[Jewelry making - Article 00157] - Re: [Orchid] Selecting kiln for PMC

[Teri]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I was using a Thomson Enamel TK-1 but recently got one with
    temperature control and must say that for the varied applications the
    one with temperature control is much better. 

    I fired it up at half setting and did PMC3 in 10-20 minutes
    depending onpiece size. I fired my first gems into pendants and it
    was a success so I am having fun. 

    THe second kiln was aquired off Ebay but
    http://www.thompsonenamel.com/ has good prices. 

    No affiliation just a happy customer 

Teri
Silver & Cameo Heritage Jewelry
www.corneliusspick.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________