[Jewelry making - Article 00119] - Re: [Orchid] Flexshaft speed control

[Noel Yovovich]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     I recently got myself a proper flexshaft (foredom type) with a
>     pedal speed control. I also purchased a badeco hammer hand pie ce,
>     but I am a bit reluctant to use it as I have a lot of trouble
>     keeping my revs under 3000 and am worried about ruining it. 

    You might want to talk to the folks you bought your flexshaft from,
    because you should be able to run it dead slow with no trouble at
    all. 

Noel
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________