[Jewelry making - Article 00071] - Re: [Orchid] More about Jump Ringer

[Rodney Abel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    We are a small user of the jump ringer system (we only cut 10-15
    ounces a day) so there are probably better people to answer your
    question although we have bought and used many systems. And the
    jumper ringer is the best by far we use the long one I would
    recommend the long unit to anyone that is making more the a few
    rings a day (more the 50 of a type) the labor savings is huge with
    the way we are set up even one a heavy ring day 15 ounces coiling the
    wire cutting and cleaning the jump rings it takes one person an hour
    with the smaller units it was a 4 to 6 hour process. As far as shaped
    jump rings I am not sure if the are available in the long unit but
    there is no cut fingers with this process and when making jump ring
    jewelry the long unit pays for itself quickly I hope this helps 

Rodney Abel
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________