[Jewelry making - Article 00780] - Re: [Orchid] [Source] Silver Trillion bezel setting

[Neilthejeweler]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

three ways come to mind here...

    If you have a source for what you need but in gold, simply cast
    duplicates in sterling. 

    Instead of rounding out a triangle, try making a curve with your
    flat wire that matches the stone, then mark off and bend the corners. 


    If you use these a lot maybe think about making your own bezel
    mandrel. It would indeed be a lot of work but if it gets the job
    done, might be worth it. If you started with a commercial triangular
    mandrel you'd need a good grinder and a steady, consistent hand. You
    may not need to do the entire length, just the size range you use
    most. 

    If you opt for using the available bezels in gold, for a two tone
    look, 18K will make a richer statement.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________