[Jewelry making - Article 00166] - Re: [Orchid] Unsoldered jump rings unprofessional?

[Mike Levi]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Ian and others who suggested it...The oval tip is one that came in
    quite handy, the seam naturally falls to the side plus the bail is
    not projecting out too far from the piece. 

    Nanz, I wish I could afford the laser welder, but finances aren't
    allowing for that splurge just yet :) I've also heard that lasers
    leave a blob of mess if you are not careful? I'd have to read
    further on the subject. Who knows, if the tax man is good to me this
    season I may treat myself. 

    Once again the Orchid community comes through in a pinch. Thanks to
    all of you.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________