[Jewelry making - Article 00113] - Re: [Orchid] Automotive hydraulic die forming

[Nicholas Carter and Felice Luftschein]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Even steel parts will deform and can break under pressure. 

    I had a 1/4" wall steel vessel fracture with just my 20 ton hand
    pumped jack before (it was unknown steel, I won't use scrap again to
    make vessels...), it made an impressively scary and pants soiling
    "Bang!", but thankfully no shrapnel. So be very careful with
    pressure vessels! 

Nicholas Carter and Felice Luftschein
www.cartertools.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________