[Jewelry making - Article 00105] - Re: [Orchid] Copper colored solder

[Michael Sabo]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Generally with that gauge and diameter wire I rely on a very slight
    hammering on the face of the jump ring while it is lying flat on a
    flat steel surface. This I do after the piece is soldered. My guess
    is two fold in regards to the hammering: A) it may harden slightly
    due to the hammering, B) the "flat" surface created by my hammering
    gives it a rigidity similar to the "ribbing" effect as in automotive
    body work, air plane wings, or machine castings. I could be wrong,
    as I say, this is from my experience and I could be "off base" (GO
    BREWERS) in my thinking. Thanks for the interest. If anyone would
    like to look at my site, I'd be pleased.... and feedback 
    (constructive) is always appreciated.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________