[Jewelry making - Article 00072] - Re: [Orchid] Has anyone burned out FIMO or sculpey?

[frank goss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Jay,

    you might want to try Protoplast, it is a plastic that softens in
    hot water and will take a beautiful impression, fingerprint detail.
    It burns out clean ( I have cast a lot of pieces with it and use the
    same burnout cycle as for wax.) when you make the impression make
    sure the intaglio is wet so the Protoplast does not stick. You can
    cast direct from the impression Available at 

        WFS Aquaplast Corp.
        30 Lawlias Park
        Wyekoff NJ 481-1443
        800-526-5247
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________