[Jewelry making - Article 00071] - Re: [Orchid] Has anyone burned out FIMO or sculpey?

[Veronica Kubat]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Jay, I'm not sure what the item is you are trying to make an
    impression from, but you could try a mold release spray and then
    using RTV compound. This works if the item has a flat back. You stick
    it down on a flat surface and brush RTV on, check for bubbles, then
    pour the RTV into the mold. If it is a flat-backed item, this will
    work. Let me know if you need more info. 

V.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________