[Jewelry making - Article 00295] - Re: [Orchid] Talented pearl driller?

[Ivan Sagel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Tani, YOU can do it!

    Seriously, it's easy. If you need them drilled through, there is
    vise available to hold it and line it. You drill halfway from one
    side, then the rest of the way from the other. That way you get a
    clean hole. They make special drill bits for pearls, they look like a
    mini version of a spade bit for wood working. If I only need them
    half drilled, I hold it in my hand and use a small ball bur. 

    You can do it! 

Thanks,
Ivan Sagel
www.wyzensageldesigns.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________