[Jewelry making - Article 00504] - Re: [Orchid] RT Blanking system

[Donna Wilson]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have the system and have used it a lot. It's hard to get really
    straight lines at first and you'll break a lot of blades. I went
    through something like 35 blades cutting my first die. Order blades
    by the gross ;-) I found that I liked BonnieDoon's system better, it
    had more stability. I managed to break a blade and run it 1/4" into
    my thumbnail with the RT system. If I were to advise someone, it
    would be to have Dar Shelton cut your dies for you...it would save a
    lot of frustration. 

Donna in VA
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________