[Jewelry making - Article 01328] - Re: [Orchid] Vulcanizing Rubber at Low Temperatures

[Jwryrubber]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Kushroo, your problem is not with your mold rubber. Your problem is
    with the Viper resin. Viper resin is not compatible with the low
    temperature cure silicones. 

    If you must continue to use Viper, contact Zero-D Products, Inc. for
    one of our Silicone RTVs. These can be cured in one hour, or over
    night--your choice. 

Best wishes,

Bill Mull
Zero-D Products, Inc.
800-382-3271 or 440-942-1150
http://www.zerodproducts.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________