[Jewelry making - Article 00830] - Re: [Orchid] First attempt at bezel setting in stainless

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Since Im not fortunate enough to have an air driven hammer piece,
>     this was done by hand with a modified punch to push (hammer) the
>     bezel over the stone. Held in place with a custom clamp securly
>     affixed to the table.
>     http://www.patpruitt.com/Orchid/Lapis%20150.jpg

    VERY nice, Pat. Even though you don't have a hammer handpiece
    (mine's flexshaft, not air), it probably wouldn't have done you much
    good anyway. Hammer and punch is probably the best way to do the job
    in stainless, anyway. Even WITH a handpiece, I probably would have
    done what you did. Again, very nice piece.. 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________