[Jewelry making - Article 00231] - Re: [Orchid] [Source] Tap and Die Set?

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Taps and dies smaller than #0 are not common industrially, but can
>     be found with a little hunting I'm sure...... 

    And you'll notice the sets come with several taps. They are the most
    fragile things for the job they are doing. They take a deft touch and
    a fair amount of practice. Mild steel is going to eat up taps until
    you get good at it... 

http://www.donivanandmaggiora.com


 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________