[Jewelry making - Article 01328] - [Orchid] Flush Setting in 316 Stainless Steel

[patpruitt.com]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thanks to Stanly Bright and a buddy of mine Kenneth Johnson for
    giving me some inspiration and knowledge base for trying this... 

    Right now im still tweaking details but did a small write up on how
    I was able to set a hand full of 4mm faceted stones into stainless
    steel plate with vairous degrees of sucess. 

    www.patpruitt.com/study stone setting in ss>flush setting 

    Setting into complex surface will be a bit harder im sure, havent
    tried it yet....anyhoo, let me know what you think of this technique
    and any tips that you might have. 

Thanks,
P AT 
www.patpruitt.com

 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________