[Jewelry making - Article 00425] - Re: [Orchid] Stones and Enamel

[Donna Wilson]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I am trying to figure out a way to use prong, tube, or bezel set
    stones with enamel. I 

    I fudge it by drilling a hole in the enamel piece (before enameling,
    of course) and then I solder a bezel cup to a mini bolt, set the
    stone (mostly cabs but you could tube set faceted like this), run it
    clear through and finish off with the nut on the back. I cup burr
    the nut after using Stay-tite for a smooth finish. I have some small
    computer pieces that I've attached to the enamel this way, as well.
    You can take a look at my website to see some examples. The enamels
    are on the last page (contact) and you have to click on the button
    where there is no writing (and sorry, no thumbnails)...I need to
    redo the website but haven't had time yet. 

Donna in VA
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________