[Jewelry making - Article 00364] - Re: [Orchid] Harbor freight's dapping set

[Dori Baumwart]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I just received Harbor Freight's 25 piece dapping block set, and am
    very disappointed. There are 24 punches, the largest of which is a
    24/25 (exactly what was advertised) but the block has 18 holes, and
    there are no punches that fit the 3 largest holes in the block
    (which are, of course, the ones I wanted to use the most). 25 minus
    18 = 7 and, since I've already identified 3 holes for which there are
    no punches, I'm assuming that there must be 4 other issues yet to be
    identified. This is too bad, since I had high hopes for the success
    of this product. I tried using the largest punch that came with it
    in the largest hole, but it just moves around too much to get a good,
    solid punch. I will be calling them today to see what they can do -
    am hoping they will pick up the charges for returning it.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________