[Jewelry making - Article 00172] - [Orchid] Raising gold to the surface

[Chaya Caron]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello Everyone,

    I have some work I did in 14K gold and I would like to raise the gold
    to the surface in order to give the finish the appearance of a higher
    carat gold. I was discussing this technique with a friend and was
    instructed to heat the piece until it looks black-ish, pickle, brush
    with a brass brush and repeat these steps about 6 times or so until
    the desired look is achieved. Well, I have tried this method but I
    have only managed to raise the copper alloy in the gold instead of
    the gold. What am I missing? Does anyone have suggestions on how to
    achieve a high carat look with 14K gold? It looks marvelous when done
    correctly. I am determined! Thanks! 

Chaya Caron
Chaya Studio
207.831.5477
www.chayastudio.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________