[Jewelry making - Article 00088] - Re: [Orchid] Matte finish to white gold

[Greg DeMark]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Joanne,

    If you are trying to do this by hand instead of with a flex shaft or
    motor you may be looking for the Scot/Brite pads from 3M. These come
    in various grits from fine to coarse. You could also look for a
    fiberglass pen. I have one that is from the 1970's so I am not sure
    where you would get them today but you might want to try an office
    supply store. 

    We use to use these on brushed steel watch cases but I prefer the
    Scot/Bright pads for jewelry. 

Greg DeMark
www.demarkjewelry.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________