[Jewelry making - Article 00038] - Re: [Orchid] Soldering or welding titanium?

[Phillip Scott]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Actually the ABI units and the PUK units will also do Titanium
    welding quite nicely. You do have to use Argon when welding with
    either unit just like with the laser, but they can all be used to
    weld titanium. If they are a pure type titanium, you will get a very
    clean bright and strong weld. There are some titanium frames which
    state they are titanium which will not weld properly. All laser
    welders including the Studio (table top) units will weld titanium
    very nicely. 

Phillip Scott G.G.
Technical Support & Sales
Rio Grande ~ Neutec/USA
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________