[Jewelry making - Article 00025] - Re: [Orchid] Finding the centre of circle

[Nanz Aalund]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Dear Karen,

    Use a dividers set to half of the diameter of the disk and then
    holding one prong of the dividers against the edge scratch a mark the
    center of the disk with the other prong. Move the dividers to another
    spot on the edge and repeat to make an "X." You should easily be able
    to make a small "X" at the center of each disk with this tool and
    technique. 

Nanz Aalund
Associate Editor / Art Jewelry magazine
21027 Crossroads Circle / Waukesha WI 53187-1612
262.796.8776 ext.228
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________