[Jewelry making - Article 00016] - Re: [Orchid] Finding the centre of circle

[James & Sonya Cantrell]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Karen,

    Perhaps you could use a scrap piece of disc and use it as a
    marking/drilling jig. That way you do all of the careful measuring
    and drilling once and then just put the jig on top of the disc and
    centerpunch where the hole should be drilled. 

good luck,
James S. Cantrell CMBJ
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________