[Jewelry making - Article 01557] - Re: [Orchid] Finding the centre of circle

[Jim']

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Quick version might be as close as the nearest manufacturing tool
    shop. Buy a set of transfer punches, and maybe a set of circle
    templates, put the template over the disk and the transfer punch in
    the circle. Tap, or hit, the punch with a hammer and there will be
    an indentation in the disk where the hole should be. Try this with
    some scrap metal or get some craft quality thin sheet metal at a
    hobby store.

Good luck in the venture.
James Good
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________