[Jewelry making - Article 00030] - Re: [Orchid] Casting and FTC

[coralnut]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Lee

>     Now, at the point where a rubber molding is used to duplicate the
>     design so that the same piece is cast over and over, the maker can
>     no longer vary the construction, design, and finish of each part of
>     each individual product as required by the regulation. This, IMO is
>     the point where the finished product can no longer be described as
>     "handmade." 

    I agree this need not be bantied too much, however, I do not agree
    with the above statement. I often make molds of favorite pieces but
    then modify the waxes heavily so as to be nearly unrecognizable from
    the original. Just a way of keeping the designs 'fresh'. Otherwise, I
    agree with all you say. 

Cheers from Don in SOFL


 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________