[Jewelry making - Article 00681] - Re: [Orchid] Kiln Controller and thermocouple

[Lee Epperson]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Congratulation on the purchase of your burn out oven controller. You
    casting life will be a bunch easier. 

    I drilled a hole for my controller thermocouple in the back of my
    oven about 2/3 up from the base. The coils are exposed and not
    embedded in the insulation. If you coils are not visible it will next
    to impossible to drill a hole as there is no way to know where the
    coils are. 

    The hole being in the back keeps the wiring out of the way. 

    It will be easier to drill from the inside to the outside. If you
    prefer to drill from the outside to the inside be sure you don't run
    into a coil. 

Lee Epperson

 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________