[Jewelry making - Article 00576] - Re: [Orchid] Old Kiln - Safe to use?

[Alma Rands]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I am not an expert, but I would think it would be safe to use the
    kiln if the cord and plug are in perfect to condition. 

    I would strongly advice that to be on the safe side, I would have it
    checked out, and if necessary have the cord and plug replaced. 

    If there is a ceramic supply house or a kiln dealer in your area,
    they usually have someone who does repairs on kilns and can advise
    you. 

    If it is a small table top kiln, a cloth covered cord may be o.k.,
    but anything larger should have one of the new cords and a polarized
    plug. 

    In other words, the kiln itself would not be a problem, but the cord
    may well be. 

Alma
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________