[Jewelry making - Article 00563] - Re: [Orchid] Raising fine silver to the surface

[Dave Arens]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Sue,

>     I usually have small recesses and tight areas that the steel shot
>     can't reach completely. 

    You didn't say what shapes of steel shot you were using. 

    I'd suggest you give the assorted shape mixture of shot a try. You
    may even want to mix in some of the long skinny stuff used in the
    magnetic tumblers if you have vary narrow spaces. The assorted
    shapes seem to get into all kinds of nooks & crannies. 

Dave
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________