[Jewelry making - Article 00553] - Re: [Orchid] Old Kiln - Safe to use?

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    If all the electrics look good, there's probably no reason not to
    test it. I'd change the cord, though. I just by an extention cord,
    cut off the female end, and wire it into the appliance - then you can
    have the molded plug thing. To ground it just screw the ground wire
    into the frame of the kiln. You should be able to test it with the
    old cord, though - then if it doesn't work you have no investment. 

http://www.donivanandmaggiora.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________