[Jewelry making - Article 00441] - Re: [Orchid] Saw dust and cabs

[Kimberly Starbard]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi M'lou

>     An alternative to filling is to put an inner rim inside the bezel
>     so that the cab sits on that rather than on the bottom plate. It
>     could be a full height inner bezel, or just a loop of square wire
>     soldered in at the desired height. Use a thicker bezel material, in
>     that case. 

    Why the thicker bezel? 

Still learning
Thanks
Kim
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________