[Jewelry making - Article 00281] - Re: [Orchid] Drilling Tubes

[Noel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi, John  

>     I made a 4cm square piece of wood with a small groove in a surface
>     to hold the tube steady. Use a woodworking countersink in a drill
>     press and clamp a piece of wood to the plate of the machine to run
>     your block against when cutting the groove. Obvious, only you
>     didn't think of it!! 

    I'm afraid I don't follow this part of your description. I'm sure it
    will turn out to be a forehead-slapper, but I don't get it yet.
    Thanks! 

Noel
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________