[Jewelry making - Article 00239] - Re: [Orchid] Problems with smith torch regulator

[J Morley]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Jamie,

    Do not use teflon tape on gas fittings also try turning the
    adjustment screw a few more turns it may take more than two. If the
    acetylene regulator is leaking you may have nicked the threads check
    the threads to see if they are nicked any where. The fittings are
    brass and easily dented and nicked. Check out smiths website for
    gauge pressure. I used acetylene for a very short time it is a dirty
    gas and is also very hot. I think if you are just starting out you
    may want to try propane it is a little easier to manage and you do
    not have little black soot floaters flying around your studio. You
    can also get a plumber to hook up natural gas if you have it at your
    house or studio. 

Regards
J Morley
goldsmith and laserwelding
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________