[Jewelry making - Article 00130] - Re: [Orchid] Drilling Tubes

[Sam Trump]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    The safest way for batch drilling of small tubes is to make up a
    jig, drill a hole the diameter of the tube, then a hole down through
    the steel block all that you then do is insert the tube the correct
    distance into the jig and drill with accuracy as many as you require. 


Sam Trump
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________