[Jewelry making - Article 01468] - Re: [Orchid] Drill Press Advice

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Some generic advise - You can drill easily on a milling machine, it's
    not so easy to mill on a drill press. Of course, even a small milling
    machine is another beast. But drill presses don't mill very well, even
    with an x-y table and stuff - they're just not made for it. 

http://www.donivanandmaggiora.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________