[Jewelry making - Article 00093] - Re: [Orchid] Enameling Kilns for startup

[Joel Elfman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thanks, Jen that is the model I thought you were talking about and I
    wanted to be sure. 

    Do you mostly work through the small front opening? It looks like
    you might lose a lot of heat popping the top, and have to wait
    awhile for it to come back to temperature. 

    Also, from looking at the picture, there doesn't appear to be any
    temperature control is that correct? 

    Thanks for helping with all the questions, it might not have been a
    model I would have considered carefully before but your
    recommendation and thoughts makes it worth a more serious look. 

Joel
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________