[Jewelry making - Article 00119] - Re: [Orchid] Enameling a cylinder

[frank goss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Aslowly revolving motor ( I use one that rotates at 7 rpm) attached
    to the tube so that it rotates on a horizontal axis will create a
    smooth even surface. If you are creating a pattern you may run into
    some difficulty with this technique. In which case paint the pattern
    on, let it dry and then do a coat of clear over the pattern,
    revolving it as it dries. Just a thought. 

Frank Goss
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________