[Jewelry making - Article 01215] - Re: [Orchid] [Source] Textured Sheet Metal?

[Matthew Crawford]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     I am trying to figure out if I should invest in an inexpensive
>     rolling mill to texture my own or just try to find a source for
>     pre-textured sheet (copper, brass, silver)? 

    You can find a good range of pattern sheet at David H. Fell Company
    in sterling, and a small but very interesting selection of cast
    relief-textured sheet at Reactive Metals (in sterling and shibuichi).
    My money's on using materials at hand (more time to use them
    creatively), unless you are not satisfied with the selection, or you
    want to create proprietary patterns. 

Matthew Crawford
www.MatthewDesigns.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________