[Jewelry making - Article 01099] - [Orchid] [Source] Base Metal Screws

[Justine Wetherington]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I've seen these in base metal. It's a two part dingus. There's a
    slot for a screwdriver on each end. From the other end of one pice
    there are male threads about 1/2 to 2/3 the length. The other piece
    is female threaded to the same depth. They screw together and form a
    "pin" or "dowel". Neat for hinges -right? 

    I'd like them in sterling or at worse nickle silver. 1 - 2 mm in
    diameter and 3-9 mm in length.

Any ideas?
Justine
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________