[Jewelry making - Article 00077] - [Orchid] Buying trim saw for slabs

[Sam Behar]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I am considering picking up a "cheap" little saw for the primary
    purpose of trimming 1/4" slabs. I've been considering two different
    saws: 

    a) Inland swaptop trim saw (~$125-170)
    b) Lapcraft's L'il Trimmer (~$200)

    I was wondering whether any one had any experience with either of
    these (or had other recommendations. My current saw is a 10" saw
    that I run in oil, and I was looking for something that I could run
    with water, to cut down the mess some. 

Any suggestions?
Thanks,
Sam
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________