[Jewelry making - Article 01400] - Re: [Orchid] Converting 220V 1HP Motor Down to 110V

[Hratch Babikian]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello Jim

    welp Initially I was trying to set up a 12 or 14 inch diamond
    lapidary saw, the motor is 3 phase now at 1 hp and 3460rpm I have
    single phase running through the studio, and you say this VFD let's
    the motor be at a variable speeds? I don't think of the diamond saw
    as haveing too heavy a load. but it will be cuting 5x7 rocks or a
    little bigger. 

Hratch
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________