[Jewelry making - Article 00636] - Re: [Orchid] Setting square cabs

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    You don't say much about what your difficulties are in setting, but
    I imagine they are the usual. That is - set the corners first. If you
    do the obvious, setting the walls first, the corners will always
    pinch in that way they do, and you will never get them back. Always
    set the corners first.. 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________