[Jewelry making - Article 00603] - Re: [Orchid] Etching Vs. Using a Jewelers Saw

[Matthew Crawford]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Sami,

>     Any other suggestions? 

    You could have the pieces laser or waterjet cut. Can be very
    economical this way if you are doing lots of them. Or you could have
    them stamped out, or do it yourself with a diecutter and press. 

Matthew Crawford
www.MatthewDesigns.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________