[Jewelry making - Article 00476] - Re: [Orchid] Milling Fixtures

[Tim Blades]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    There is this company. I don't know if they are the same. 

    http://millfixtures.com/html/fixtures_selection.html 

    Although I dont have the software yet I have found a lot of helpful
    info on the Artcam Forum. You can join for free unlike some of the
    others, it is a very busy group. 

    Roland in Australia do some interesting fittings, not cheap and
    maybe not what you want but food for thought if you can make up
    fittings of your own 

    http://www.rolanddg.com.au

regards Tim.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________