[Jewelry making - Article 00160] - Re: [Orchid] Economy Rolling Mills

[Kimberly Starbard]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Everyone:

>     I see that is comes with five rollers so you have the ability to
>     swap in different ones as needed. it is smaller than some at three
>     inch width, but the rollers are 1.675" dia. so think will be
>     sturdy, yes they are hardened. it has a 3:1 gear ratio. 

    I am also looking at a mini model. The one I am looking at also has
    interchangeable rollers (3 of them). My question is, is there a
    great probability with switching rollers in and out that things will
    not be in proper alignment? 

    This model is a couple hundred dollars less than the one I had
    previously looked at. I would love to save the money, but i won't
    sacrifice quality for a lower price. 

Thanks
Kim Starbard
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________