[Jewelry making - Article 00149] - [Orchid] Dremel to enlarge holes in beads?

[Peggy Li]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi there,

    My dad just got me a dremel tool and I was wondering if there were
    any tips on being able to use such a tool to enlarge bead holes in
    stones or pearls? In particular, I was hoping to enlarge a hole in an
    azurite piece. 

    If this is possible, is there a special bit or technique to use
    (water, slurry, safety)? 

thanks so much,
peggy li
www.peggyli.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________