[Jewelry making - Article 00096] - Re: [Orchid] Buying My First Rolling Mill...

[Alma Rands]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have a very very inexpensive rolling mill---Karet, made in India.
    It came with flat rollers, and several other rollers for wire. I
    have had it for about 5 years and so far have had no problems at all
    with it. I use it to do texturing, Roll heavy gauge sheet into
    thinner when needed, and have even rolled out thin sheets of silver
    foil to use in enameling. I purchased it from Kenneth Singh (think I
    have the correct spelling), who was very helpful in advising me how
    to set it up, adjust the rollers etc.. I have no reservations in
    recommending it, especially as you will not be doing any heavy-duty
    production. 

Alma
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________