[Jewelry making - Article 00051] - Re: [Orchid] An old engraving block

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I hope this doesn't sound bossy or something like that, but do NOT
    put JB weld on your beautiful, precious, vintage engraving block.
    You could perhaps try tubing. What you have are holes that are .007"
    smaller that 5/32", though. You can get 5/32" drill rod here: 

    http://tinyurl.com/jvmrh 

    You can shave off the .007 by chucking it in your flexshaft, or
    various ways, and also turn the edge. You might have to anneal it and
    then reharden it. Heat it red hot and leave it alone to anneal, do
    the same and quench it in cold water when it's all done to harden.
    You could probably find a smaller quantity for less $ than the above
    link, but it's just to show you. Putting glue in the holes is spray
    painting a chippendale chair...... 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________