[Jewelry making - Article 00041] - Re: [Orchid] Rolling Mill disengaging

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    It's very simple, and completely normal. If you look up inside, near
    the crank, you will see the two gears that drive the rollers. You
    are opening the rollers to the point where the gear teeth are no
    longer engaging. Regardless of how far it appears the rollers will
    go, it is the gears that give the maximum opening, in reality. You
    can do various things, but I just pull out the big hammer and smash
    down the ingot until it will fit... 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________