[Jewelry making - Article 00010] - Re: [Orchid] Rolling Mill disengaging

[Durston Rolling Mills]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Linda,

    Yes, this is totally normal. The maximum a Mini Mill will roll out
    is 5-6mm. 

    At 10mm the rolls will definitely disengage. This is the same case
    for all 

    Rolling mills. The larger mills do have a stop collar to stop the
    rolls Opening up to more than 6-7mm. 

Matthew Durston

Durston Rolling Mills
Progress House, Hospital Hill
Waterside, Chesham, Bucks.
HP5 1PJ England
Tel: + 44 1494 793244
Fax: + 44 1494 792966
www.durston.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________