[Jewelry making - Article 01062] - Re: [Orchid] Selecting appropriate torch tips

[daniel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I found out something that might be of interest. The cheap torches
    and tips they sell for use with the little Propane tanks at the
    hardware store, The tips fit my Meco! They are bigger than a meco 3
    tip propane tip. One I use to melt, and man does it work great. The
    other one I had, I opened the tip up just a little with a drill bit,
    and silver soldered the stainless tip off a glue syringe into it as
    it. the flame is hard to get correct, but its a little smaller than
    the #3 on my smith. 

daniel

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________