[Jewelry making - Article 00020] - [Orchid] Rolling mills and metal cutters

[Cyndy Wolf]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello all,

    You all responded so generously to my torch/fuel dilemma that I now
    feel fully informed and can make an educated decision - at last!!! 

    Your thoughts please on rolling mills. The prices vary widely and
    probably the quality too. What I'm looking for is something of decent
    quality, not too big, that can also roll down wire. After that the
    only other biggie I feel I need right away is a guillitine type metal
    cutter. 

    All thoughts, preferences and tidbits of information are Greatly
    appreciated!. 

Cyndy

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________